IP67 Live end with 3 metre cable

£4.80
Tax included.

Power your waterproof LED strip straight from the driver, with the seal intact. The Arcova IP67 live end connects to the start of your strip and seals the connection, so the run stays fully waterproof right from the power-entry point - no weak spot where the cable meets the strip. A generous 3-metre 2-core lead gives you the slack to site your driver out of sight while keeping the strip itself clean and uninterrupted.

The sealed, solderless design means a secure, reliable feed without heat, flux or cold joints - fit it, wire it, done. Built for the wet and outdoor runs where a standard live end would let water in.

📄 Download Datasheet (PDF)

IP67 sealed feed - keeps the strip's waterproof rating intact at the power connection
3-metre 2-core cable - flexible driver placement for single-colour 24V runs
Solderless - no heat, flux or cold joints
Pre-prepared cable ends ready to terminate into your driver or power supply
Built for wet and outdoor areas - bathrooms, kitchens, garden and eaves lighting

Specifications

Type: Single-feed live end (strip-to-driver), sealed
Cable length: 3 metres
Cable: 2-core x 0.5mm²
Wire termination: Tinned bare ends
Compatibility: 10mm IP67 SOB LED strip
Pin configuration: 2-pin, single colour
Voltage: 12–24V DC
Max current: 3A
IP rating: IP67 (dust-tight, immersion protected)
Housing: Clear polycarbonate, sealed

Lighting for Modern Spaces

Our lighting systems combine advanced LED technology with minimalist design, delivering clean, continuous illumination that integrates beautifully into modern architecture.