Arcova IP20 LED live end with 20cm cable
Arcova IP20 LED live end with 20cm cable - detail view
Arcova IP20 LED live end with 20cm cable - alternate angle

IP20 Live end with 20cm cable

£1.80
Tax included.

Power your LED strip straight from the driver with no soldering required. The Arcova live end clips onto the start of your strip.

The solderless clip grips the strip's contact pads directly for a secure, reliable feed, while the pre-prepared cable ends terminate quickly into your driver or power supply. A simple, fast way to energise a run - fit it, wire it, done.

Compatible with Arcova's Aura SOB IP40 LED Strip.

📄 Download Datasheet (PDF)

Solderless, tool-free installation - clips straight onto the strip's contact pads
20cm cable gives room to route power neatly back to your driver
Tinned bare cable ends, ready to terminate into your driver - no soldering required
Low-profile clear housing sits discreetly in profile or behind diffuser
No heat, no flux, no cold joints

Specifications

Type: Single-feed live end (strip-to-driver)
Cable length: 20cm
Cable: 2-core x 0.5mm²
Wire termination: Tinned bare ends
Compatibility: 8mm single-colour LED strip
Pin configuration: 2-pin, single colour
Voltage: 12–24V DC
Max current: 3A
IP rating: IP20 (indoor / dry use only)
Housing: Clear polycarbonate

Lighting for Modern Spaces

Our lighting systems combine advanced LED technology with minimalist design, delivering clean, continuous illumination that integrates beautifully into modern architecture.

Shop By Category

LED Strip
LED Strip
Profiles
Profiles
Drivers
Drivers
Accessories
Accessories